i-Power

, an American authority in finance and economics magazines, revealed two startling findings: Electricity cost constitutes a third or a fourth of the total costs of a corporation. A corporation does not seem to be able to control its electrical expenses. This is a cost that is relatively large among all other expenses in a corporation. Sadly however, most of the corporations have not been able to control this cost effectively. Payment to the utility company will be in accordance with the amount stated in the bill as it seems uncontrollable and it is a must to pay up. Over time, these corporations have spent a huge sum on unjustified electrical expenses.
For the few corporations and users that have taken note to control electrical expenses, they have been brain-washed by the utility company, media as well as those who do not understand the laws pertaining to electricity . Many had the wrong notion that saving electricity is equivalent to stealing electricity. They wish to control the electrical expenses but do not dare to do so.
The lack of legal knowledge is the main cause of wastages in electrical expenses in corporations and users. I-Power is a device that maximizes the use of electrical power and avoids wastages. It is able to provide the most practical power factor for all types of electrical devices and hence, reduce the cost of electricity. The device is installed at a legally allowed location and fully complied with the law on electricity.

Our modern living cannot be possible without the presence of electrical power. We need wide variety of electrical products to assist our normal day living to ease our life. For example, when you at home, you can get clean water hot and cold at a turn on your tap water, frozen food are meters away from you in the fridge, cooked rice and fried foods, clothes laundry and all handy devices you need to operate, are very dependent on electrical power. More than 80% of our daily needed electrical energy are generated by fossil (oil) burning power plants. And followed by charcoal burning is our secondary source of electrical energy generated from. So call new source of energy like nuclear power, wind power, water power, solar power etc, still not enough to cover 10% of current day power needed. And we all now, by another 100 years, we will be out of fossil energy supply, which mean, the limited resources will definitely increase our electrical bill in near future. We can feel that now, when we see highly increase electrical bill this month compare to years ago. Since we cannot live without this energy supply, we have to manage or improve efficiency on using energy to reduce cost we spend on everyday activities. By doing so, we can enjoy same standard of living without giving up conveniences. And to do so, we need to understand a technical term, we call “Power Factor”. Nowadays, high tech countries like JAPAN and USA, European Nations, etc, they uses a lot of microchip in newly designed electrical devices so to use AI (Artificial Intelligent) to improve Power Factor of their new electrical products. This will not only save power consumption but at the same time reduce carbon emission for greener environment. But most of our Asian products made in development countries are not so high tech and other factory like selling price, production cost, infringement of patents, and lack of technical know-how etc. hold us back from making high efficient electrical products. Plus our consumers are not ready to know power management on electricity, so they make decision in getting new electrical products mainly by the appearance design and pricing, without knowing that, even they get the product at lower price, but in actual fact they will end up paying more as the Power Factor of the purchased item are really low. So they have to pay more money every time they use it. Averagely, more than 70% of current house hold appliances are built without power saver circuit, so with our newly design i-POWER, we use newest tech with computer chip and voltage-current phase adjustor, it can improve Power Factor of your house hold electrical devices to achieve power saving, , better energy efficiency and regulate supplied voltage, so to make your monthly electrical bill lower, prolong your electrical products life-span, and achieve better Power Factor for greener environment.                back to top

1) This model of i-POWER is specially design for area that supplied voltage is range from 200V-240V. Please check and confirmed your area are in this voltage range. DO NOT use this model of i-POWER in 100-110V area.

2) Try to use i-POWER with all other house hold electrical devices you have in one connected circuit. Like in Kitchen area, connect fridge, washing machine, lamps and lights, water heater etc in 1 circuit. But if your devices are too far apart, then you will need more than 1 unit of i-POWER to achieve good results.

3) If you are not sure of what electrical devices are connected in 1 loop, you can use i-POWER at those power socket that connect to high consumption products like fridge, TV, air-cond, etc.

4) Use extension wires if necessary, you can use one of the port on the extension for i-POWER and the rest for devices you need to improve Power Factor. But DO NOT overload the wire extension unit that you buy ! Check the maximum load bearable on the product before you use ! Also use only those with safety pass from your country authority. Our company will not be responsible on any damage or accident occurs due to the overloading of devices on extension wire ports you use.

5) Japan ZEROMAX do 3 Quality Control check before shipping out each i-POWER to our valued customer. Each component was carefully checked, function of i-POWER, and the outer look of the i-POWER etc, too. So you can safely and comfortably use i-POWER when you received them.

i-Power 3000 has the most stringent safety, performance and reliability test conducted by international and local approving statutory bodies. It is CE tested & technically compliant with the EN61000-6-3:2007, EN61000-6-1:2007, EN61000-4-2:2008, EN61000-4-3:2006, EN61000-4-4:2004, EN61000-4-5:2005, EN61000-4-6:2008, EN61000-4-8:2001, EN61000-4-11:2004 requirements.

i-Power 3000 Electricity Saver has gone through the following stringent tests :-

1. Conducted Emission Measurement
2. Radiated Emission Measurement
3. Power Harmonic measurement
4. Voltage Fluctuations
5. Electrical Discharge immunity Test (ESD)
6. Radiated Emission Measurement (RS)
7. Electrical Fast Transient / Burst (EFT)
8. Surge Test
9. Immunity Test To CS Conducted Disturbance (CS)
10. Power Frequency Magnetic Field (Magnetic)
11. Voltage Dips And Interruption Measurement

To Download this image, please click HERE

1) Check and make sure your house hold supply voltage is 200V-240V.

2) i-POWER is designed by Japan ZEROMAX, so the outer look of the device is Japanese look and the power plug is also made to Japan specification. But the inner circuit has been specially redesign to suit 200-240V area, so we enclosed 2 pieces of special adaptor connectors in this export kit. Please ensure you use the right connector for your area. There is another adaptor that looks like twin-peaks, is for holding i-POWER on the vertical wall straight to avoid over stressed on i-POWER when installed. Stick this twin peak connector when you use i-POWER on vertical wall.

3) After you have checked all connectors and apply them correctly, you can plug i-POWER into your house power socket.

4) Turn on the Power Switch on the side of i-POWER, you will see the front LED glow, and it means i-POWER has started its function from that moment.

5) This export model of i-POWER has this special LED indicator, which is specially design to work as a night assist lamp, so it will light up the path or corner where you install i-POWER. So you can plan and use i-POWER at the corner you need some cozy light in the night.

6) i-POWER special LED light is made from low consumption super bright LED, so it consume almost no energy compare to what i-POWER is going to save you back. So enjoy this extra benefit without worrying your will have higher electrical bill.